Conversion Bulletins.

To read the PDF files you need Acrobat reader installed on your computer.

HMF-02
Procedure to block the case flushing feature (PDF, 173,Kb)
Procedure to exchange purge valves (PDF, 211,2Kb)
Procedure to exchange cross-over relief valves (PDF, 286,8Kb)
Procedure to use the cylinder barrel compression plated for bearing removal from
     HMF-02 motors (PDF, 166,9Kb)
Procedure to exchange drive shaft (PDF, 527,9Kb)

HMR-02
Procedure to block the case flushing feature (PDF, 175,Kb)
Procedure to exchange purge valves (PDF, 208,7Kb)
Procedure to exchange displacement override blocks (PDF, 301,3Kb)
Procedure to exchange controls (PDF, 260,3Kb)
Procedure to convert an HMR-02 with a counter balance valve to an HMR-02 without a
     counter balance valve (PDF, 443,5Kb)
Procedure to use the cylinder barrel compression plate for bearing removal and lube tube
     shimming on variable displacement units (PDF, 301,Kb)
Procedure to exchange drive shafts (PDF, 839,6Kb)

HMV-02
Procedure to block the case flushing feature (PDF, 177,1Kb)
Procedure to exchange purge valves (PDF, 255,4Kb)
Procedure to activate the 'F' port (PDF, 335,9Kb)
Procedure to exchange Two Position controls (PDF, 402,5Kb)
Procedure to use the cylinder barrel compression plate for bearing removal and lube tube
     shimming on variable displacement units (PDF, 301,Kb)
Procedure to exchange controls (PDF, 639,8Kb)
Procedure to exchange drive shafts (PDF, 839,6Kb)

HMV-02 Double Motor
Procedure to exchange pressure compensator springs (PDF, 284,7Kb)
Procedure to externally disable the load sense (PDF, 302,0Kb)
Procedure to exchange controls (PDF, 221,3Kb)
Procedure to exchange solenoid on LS/VD3 controls (PDF, 212,6Kb)
Procedure to install a PTO kit (PDF, 409,0Kb)
Procedure to use the cylinder barrel compression plate for bearing removal and lube tube
     shimming on variable displacement units (PDF, 301,Kb)
Procedure to exchange drive shafts (PDF, 839,6Kb)

HPV-02
Procedure to exchange response orifices (PDF, 323,8Kb)
Procedure to exchange cold-start relief valves (PDF, 216,3Kb)
Procedure to exchange charge relief valves (PDF, 191,0Kb)
Procedure to exchange combination relief/make-up valves (PDF, 246,7Kb)
Procedure to install a filter elimination block (PDF, 217,6Kb)
Procedure to exchange controls (PDF, 384,6Kb)
Procedure to conver to an HPV-02 pump with cam control (PDF, 518,2Kb)
Procedure to exchange drive shafts (PDF, 1214,4Kb)
Procedure to exchange rotation (PDF, 836,5Kb)
Procedure to install power take-off (PTO) kits (PDF, 641,1Kb)
HPV-02 Charge Pump Configuration Change (PDF, 274,1Kb)
Procedure to use Cylinder Barrel Compression Plate for Bearing Removal and Lube Tube
     Shimming on Variable Units (PDF, 810,1Kb)